Description The SparkFun GPS-RTK Dead Reckoning Kit (SMA) gives precisely what you need to get started using u-blox's ZED-F9R and GPS Real Time Kinematics. The SparkFun ZED-F9R GPS Breakout is...

Description PCB edge mount RP-SMA RF connector. Perfect for prototyping with our RF ICs. This is a standard edge connector. The thickness between pins is 0.063" so that it can...

Description PCB edge mount - SMA RF connector. Perfect for prototyping with the GPS and Cellular devices that require an antenna connection. These connectors have a female signal pin and...

Description This is an adapter that converts an RP-SMA board to an SMA antenna. The adapter will connect to any of our 2.4GHz wireless boards (Bluetooth, Nordic, or XBee) or...

Description This is an inner thread (outer nut) adapter that will connect to any of our wireless boards or interface cables and allow you to use an antenna/cable that has...

Description This is a very simple 1m long Male RP-TNC to Male RP-SMA cable. We like to use this cable to connect our ultra high-frequency RFID antennas to an equally...

Description This aluminum adapter converts the very common 1/4" thread found on camera tri-pods and mono-pods to the 5/8" 11-TPI (threads per inch) found on high-end surveying antennas and equipment....

Description This small form-factor antenna offers a 2.4GHz frequency range. These antennas offer adhesive backing that simplifies mounting within the device for a FPC or PCB. Just connect the antenna...

Description This adhesive, dual band antenna is perfect for situations when you're trying to get a signal out from a transmitter that you've jammed down into an enclosure. Operating on...

Description This SMA to U.FL Cable is commonly used to connect boards with the compact U.FL connector to an enclosure wall. This allows an external antenna to be attached. What...

Description This RP-SMA to U.FL Cable is commonly used to connect boards with the compact U.FL connector to an enclosure wall. This allows an external antenna to be attached. What...

Description When experimenting with GPS or RF it can be very handy to have the antenna on the top of your house or car with a clear view of the...

Description This is a 915MHz SMA Duck Antenna for use with the AHPI7292S WiFi HaLow HAT. We've distinguished it as for use with this HAT as it's an SMA connection...

Description 2.4GHz ceramic chip antennas. Very small antennas that work nicely with the Nordic ICs. Don't expect these little guys to perform as well as their ~2" rubber duck counter...

Description This is a basic SMA (Sub-Miniature A) male to female connector cable. Each cable is 25cm (9.8") long and has a 50Ω impedance that can handle frequencies up to...