Presenting our MOSFET PWM Switch Control Board, the core of power management accuracy. This small but mighty board is made to smoothly operate MOSFET switches, giving you an effective PWM...

Trigger signal source: digital high level (DC3.3V-20V), can be connected to the microcontroller IO port, PLC interface, DC power supply, etc., can connect PWM signal, support signal frequency 0-20khzOutput: DC5V-36V,...

The AOD4184 module is an isolation MOSFET (Metal-Oxide-Semiconductor Field-Effect Transistor) control module that uses an optocoupler for signal isolation and a MOSFET to switch high-power loads like motors and solenoid...

FR120N Mosfet control Module features with optocoupler to provide electrical isolation between the high-powered MOSFET side and the logic signals used to control the module this will prevent damaging the...

LR7843 Mosfet control Module Replacement Relay comes with optocoupler isolation, the control signal and the power of the controlled device are isolated, which greatly increases the rigidity of the interference....

Power supply:3-5V, which can be accessed by pin power;Audio recording control mode: the key to control or microcontroller, IO has drawn the line of control;Buttons control audio recording method of...

The Device is a mnolithic integrated high voltage, high current four channel driver designed to accept standard DTL or TTL logic levels and drive inductive loads (such as relays solenoides,...

MOSFET is an electronic devices with good switching characteristics. It is widely used in circuits, such as power supplies switching , motor drives, lighting dimmer and so on. Relay is...

It Can achieve an interface with a voltage level of 3.6-24V controlled by 3.3V or 5V. After the control terminal is connected, the controlled terminal will also be connected. Strong...

This is a AC Light Lamp Dimming LED Lamp and Motor Dimmer Module 1 Channel-8A. The AC Dimmer is designed to control the alternating current voltage, which can transfer current...

LM358 Gain Amplification Module Operational Amplifier Module is based on the LM358 operational amplifier which is a high-gain, frequency compensated operational amplifier designed to operate from a single power supply...

The ACS712 30A Range Current Sensor Module / Hall Sensor device consists of a precise, low-offset, linear Hall circuit with a copper conduction path located near the surface of the...

This module is based on the design principles of the resistor divider, to make the terminal interface input voltage narrow five times, Arduino analogue input voltage up to 5V, then...

CP2102 is high integration, built-in USB2.0 full-speed function controller, USB transceiver, crystal oscillator, EEPROM, and asynchronous serial data bus (UART), supports full-featured modem signals, without any external USB device. CP2102...

CJMCU-ADS1115 16-Bit Precision Analog-to-Digital converter ADC Module Development BoardPROGRAMMABLE DATA RATE: transferred via an I2C-compatible serial interface; 8SPS to 860SPS I2C slave addresses can be selected.- PORTABLE INSTRUMENTATION automatically powers...