High quality relay. On board SMD optocoupler isolation. The module can be set high or low by a jumper setting trigger. With a fault-tolerant design, even if the control line...

This is a 1 channel solid state relay module. It allows you control the switching of high voltages and currents using a 5V signal coming from a microcontroller. Maximum acceptable...

1) N20 gear motor:Body Size(Including Reduction Box):35.8 x 10 x 12mmShaft Diameter: 2.9mm, D ShaftShaft Length: 9.4mmVoltage: 6vNo-load speed: 300RPM ±10% 2) Rubber wheels:Diameter:44mmThickness:17.7mmAperture:D Shaft 2.25mm holeMaterial: ABS engineering plastics+import...

Are you searching for a good Quality RGB Strip driver? Here you can end your search. This 12V 5050 RGB LED Strip Controller box with 24 Key IR Remote Control...

This is RFID 13.56MHz Card used for Contactless transmission of data and supplies energy with no battery needed. Its Operating distance is Up to 1 Meter depending on antenna geometry....

The 1N4007-T is a Rectifier Diode with molded plastic case. The rectifier diode has high current capability and low forward voltage drop. Diffused Junction. High Current Capability and Low Forward...

Battery Type: AA Alkaline Battery Voltage output: 1.5V (when using AA Alkaline Battery) Number of batteries: 1 battery  

Battery Type: AAA Alkaline Battery Voltage output: 1.5V (when using AAA Alkaline Battery) Number of batteries: 1 battery

The 2 Channel Relay Module gives you the power to control high voltages and currents using a 5V signal coming from a microcontroller. You can now turn on and off...

This chip has 4 AND gates and each gate has two inputs and one output. It can be powered by 5V. Which makes it ideal to be used with any...

This chip has 4 AND gates and each gate has two inputs and one output. It can be powered by 5V. Which makes it ideal to be used with any...

This chip has 4 NAND gates and each gate has 2 inputs and one output. It can be powered by 5V. Which makes it ideal to be used with any...

This chip has 4 NAND gates and each gate has 2 inputs and one output. It can be powered by 5V. Which makes it ideal to be used with any...

This chip has 4 OR gates and each gate has two inputs and one output. It can be powered by 5V. Which makes it ideal to be used with any...

This chip has 4 XOR gates and each gate has 2 inputs and one output. It can be powered by wide range of voltages 0-7V. Which makes it ideal to...