This easy to use 3-6V DC motor has alligator clip leads, making it easy to hook up without any tools! The motor is ideally suited for beginners and can be...

Infrared Obstacle Avoidance Sensor Module is very easy to interface directly with Arduino or other micro-controllers. It also works with the Raspberry Pi with a voltage range of 3-6 volts....

Soil moisture module is most sensitive to the ambient humidity is generally used to detect the moisture content of the soil.Module to reach the threshold value is set in the...

A SRD 24V SPDT Relay is an electrically operated switch that uses a 24-volt DC coil to control a higher-power load, acting as a single-pole, double-throw (SPDT) switch with one...

A SRD 5V SPDT Relay is an electrically operated switch that uses a 5-volt DC coil to control a higher-power load, acting as a single-pole, double-throw (SPDT) switch with one...

A SRD 9V SPDT Relay is an electrically operated switch that uses a 9-volt DC coil to control a higher-power load, acting as a single-pole, double-throw (SPDT) switch with one...

SS-5GL is an ultra-compact, highly durable micro limit switch known for its 30-million-cycle mechanical life, achieved through a stable two-spring structure. Key features include varied actuator options (pin plunger, lever,...

The GUVA-S12SD UV Sensor chip is suitable for detecting UV radiation in sunlight. It can be used in any application where you want to monitor the amount of UV light...

This Momentary Tactile Push Button Module DC 5V Switch is ideally suited to add a button to your projects and gives a high signal when it is pressed. The module...

This Momentary Tactile Push Button Module DC 5V Switch is ideally suited to add a button to your projects and gives a high signal when it is pressed. The module...

The DS18B20 digital thermometer provides 9-bit to 12-bit Celsius temperature measurements and has an alarm function with nonvolatile user-programmable upper and lower trigger points. The DS18B20 communicates over a 1-Wire...

The DS18B20 digital thermometer provides 9-bit to 12-bit Celsius temperature measurements and has an alarm function with nonvolatile user-programmable upper and lower trigger points. The DS18B20 communicates over a 1-Wire...

Genuine Creality Thermistor kit for easy replacement of faulty thermistors of any model of Creality 3D Printer. Features Easy Installation High Precision Nice Stability High Sensitivity

Thermistors are resistors that change their resistance value with the temperature. They are small, often the size of an ant, but they can also have wires that extend their range....

An NTC (Negative Temperature Coefficient) is a resistor with a negative temperature coefficient. So the resistance decreases when the temperature increases. Connect this to an analog port on your Arduino,...