FR120N Isolation MOSFET MOS Tube Field Effect Transistor

FR120N Mosfet control Module features with optocoupler to provide electrical isolation between the high-powered MOSFET side and the logic signals used to control the module this will prevent damaging the MCU if something goes wrong in the load connections and also increases the rigidity of the interference. PWM speed regulation is widely used to control the start and stop of the motor. The signal input side can be soldered to the terminal or pin itself, compatible breadboard output can be soldered to the terminal or direct wire.

Widely used for switching applications requiring moderate to high currents of up to 9.4A at 100V. The circuit has an optocoupler on the input that separates the input from the output load voltage and is unaffected by the logic levels applied to the driving signal. It works well for basic ON/OFF operations like controlling a solenoid or PWM control like dimming an array of LEDs. Additionally, these modules may be connected in parallel to boost the power handling capacity.

Features

• With optocoupler isolation, the control signal and the power of the controlled device are isolated, which greatly increases the rigidity of the interference.
  
• Compatible with MCU and control board, 3V or 5V signal
  
• High-level start, low-level stop, PWM speed regulation
  Widely used to control the start and stop of the motor, solenoid valve, and other tributary equipment
  
• The signal input side can be welded to the terminal or pin itself, compatible breadboard
  
• Output can be soldered to the terminal or direct wire
  
• Module size 23mm X 16mm There are two 2mm diameter screw holes, hole spacing 8mm
  Specifications of MOS tube: 100V 9.4A